BCQuilter's Weblog

Posts Tagged ‘pieced border

Just like a snowball rolling down a hill, this quilt got bigger and bigger.

You may reading the adventures of the snowball quilt.  At that time, I was trying to decide on border options.  As per usual, a different idea developed on its own.

With a snowball block, you end up with half square triangle bits left over.  Instead of having to deal with these triangles, I decided at the time of making the snowball blocks to stitch to seam lines, and save the remaining pieces for something.

That something developed into an idea for a border.  I have always wanted to do a pieced border, and this seemed as good an opportunity as any.

I have the top completely done.  I stitched the HSTs into pairs, and then stitched the pairs into long strips.  I had no idea how long I needed them, so I just stitched until it seemed right, and I had four borders ready.

For the two dark red borders, I cut strips 2′, and strip pieced them together.  I had three different dark red fabrics, and randomly stitched the strips together.  Some were 4, 5 or 6 strips wide.  I then sub-cut these to 2″.  And randomly grabbed from different piles and stiched them together.  I continued stitching them until I had four borders.  Oh oh… I forgot I wanted a second border, so more stitching went on.

I then measured the quilt and found my first border length.  Cut, pinned, stiched, and did the same with the other borders.  One thing I realized when I was partially through the first borders, that I would have cut them to fit differently.  Of course when you are working with 1½” finished pieces, they do not adjust very well to the size of my quilt.  (This is one of those ideas, that squaring up the blocks as you go, would have been a very good idea – one I didn’t follow).  I trimmed the last unit of the strips to fit.  Next time, I think I would like to measure from the center of each border, to the end, and cut off each end to fit the size I needed.  This quilt was a learning experience!  What better way to experiment, than with scraps!

In my mind, I think if I had measured from the center point, then all the seams for the three borders would have lined up.  As it is, one half of each border lines up, the other half does not.  But shhh… if no one looks really close, maybe they won’t notice.  🙂

It was a nice day outside, so I hung the quilt top on the line, and took a photo.  The sun is kind of shining behind it, giving it some interesting shadows.  The next step is to get this quilt, sandwiched, quilted and finished.

I don’t quite have enough energy to get that far, yet.

The fabrics for this quilt came from my stash, and my scraps.  Some of the pieces, are from cotton shirts I purhcased at the local thrift store, and cut up.  I wanted to make a quilt with a more masculine feel to it, and one way of doing that, was by buying the shirts!  Insted of just using blues, browns, greens.  Why are those colours more often used to represent male?

I am happy that this one is done.  I think I started it three years ago (practically to the month!).  I started making the snowballs as a leader/ender and then earlier this year, I thought enough was enough, it was time to get it finished.


Food for thought:   Have you ever “shopped” your stash to make  a quilt?  Do you have bits and pieces of fabric left over from projects, and they are odd shaped and sizes?  Take 15-20 minutes and start cutting them into useable pieces.  You don’t have to do it for long, and you’ll be surprised how quickly those messy scraps can be made.   You can even make a “free” quilt by using up your scraps.  Don’t put a time frame on it.  Just take a light and a dark piece, stitch them together, each time you are working on a quilt, at the begining and end of each strip you piece.  Once they are stitched, press, and place in a bin.  Before long you will have enough pieces for a 4-patch, 9-patch or any other block you desire.  For more great scrap busting ideas, be sure to check out Bonnie K. Hunter’s blog and website.




As you can tell from the previous posts, I am using my Fast Scrappy Quilt as a learning process. Well, why not, I am all about learning.

I have decided to piece one of the borders. To make a flying geese border in fact.

As I mentioned in my previous post, there are many ways to make flying geese. I have used rectangle and 2 squares technique.   I also did another little thing. I’m making ½ square triangles in the process… who knows… it could become a “free quilt”.

Are you intrigued? Okay… this blog will be more of a photo blog.


Many books and quilters will mark a line from corner to corner on the squares.  I chose to press, and use that line to stitch on.  If you find it difficult to see the crease while stitching, I recommend marking.


Here are a number of the squares pressed in half.


Some people will pin.  I haven’t.  You can just make out the creases or stitch line.


Here I am stitching along the crease/fold.  I also chain piece.  I like to piece from the outside corner to the centre edge.   I do about 6 before I snip them off to cut and press.  Coming up, I’ll explain why I only do a small amount.


Now to trim off the unnecessary parts.  I line the 1/4″ mark of my ruler along the stitch line, and trim off.


When you are making  flying geese, you will get a lot of unneccessary bits.  Keep reading to find my solution to all these bits.


In making flying geese using the rectangle and 2 squares technique, you always end up with 4 triangle pieces left over. In some cases they are quite small to try and stitch together. Well, I wasn’t about to toss them out.  I can’t remember when or even where, I read about this.  Instead of just trimming off those extra bits, and having them sit around, add another seam 1/2″ away from the first, to create a pre-stitched half square triangle.  I estimated where the 1/2″ was.  It does need to be 1/2″, as you will cut 1/4″ away from the stitching line to cut 1/4″ seams on both your flying geese piece and the half square triangle piece.   Free pieces for making a free quilt.


You can premark both stitching lines.  After marking one to demonstrate, I’m thinking this would be faster than pressing 400+ squares for the flying geese.


These pieces have the double stitched seams.


I’ve aligned the 1/4″ mark on the long stitch line, and cut.   Admittedly not all my half square triangles have perfect 1/4″ seams, as I have “eyeballed” the distance between seams.


The pressed open beginning of a flying geese block and a half square triangle.  Remember I mentioned only doing about 6 at a time.   Can you imagine having to press 20+  flying geese open, and then pressing open 40+ half square triangles?   Little bits in moderation!  I’m not saying it can’t be done, but with my back the way its been, sitting and standing for any length of time is not a happy thing, so I do little bits here and there.


Laying out the second square.


Again, I like to stitch from the corner to the centre.


Two pieces with the second square double seamed stitched.  How odd that sounds.


Trimming the second half square triangles away.


Two flying geese and two half square triangles.  Remember… for each flying geese (goose), you will have two half square triangles.  If I was careful with the measurement of the 1/2″ between the seams,  I might have been able to get a bit larger square.  As it is, most are trimmed down to 1 3/4″ squares.

So what to do with all those half square triangles?  Originally all the pieces were put into a bag, for my DD#2 to perhaps do something with… or me, when I was ready to work out another scrappy type quilt.   Then another idea struck me, and yes, I am okay!

I made a comfy critter (another blog about that soon – or check out my blurb about it at AllPeopleQuilt.com).   As they are made from large patchwork panels, I thought that colour coordinating some of the half square triangles and arranging them in different ways, would be a great way to make more of these critters.   I’m not sure about the all the black, but it does set off some of the colours quite nicely.  It is something I’m working on.

Then I started thinking, as I was laying out the half square triangles for the photo shoot for this blog, that perhaps, I could just colour coordinate and make blocks, then stitch all the blocks together… and perhaps a free quilt!  Gotta love that idea.


Purple and pinks coordinated.   Stitched up this particular arrangement would make a block approximately 6″ in size.  Remember… I did say, I was going to end up with 400+ half square triangles… no, I haven’t calculated how big ti would end up!  LOL.  Of course, the pieces could be re-arranged to create any number of design combinations.  Or perhaps other things could be made from them… pot holders, trivets, doll blankets… the possibilities are endless.

Then I started thinking… and re-arranged the squares.


Remember, this was on the fly, and the corner pieces would have to be something else… but I could always use these pieces for a border.  Not on this quilt, but on another.  Just some ideas.

It is going to take me some time to finish my flying geese.  I am in no rush.   It may be sometime before I get the next step done for this quilt.  But I when I make some progress, I’ll be sure to let you know.

I’ve asked you what you do with your scraps.  Now what do you do with the left-over bits.   If you’ve been tossing those triangle bits, perhaps rethink that… and save them and use them for another quilt.  You may find you have a free quilt, you didn’t even know you had!


Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 99 other followers


July 2018
« Feb